N° 777
|
Defect recognition on saw blade discs
Defects on saw blade discs should be detected.
|
|
N° 107
|
電気部品のピンの幅検査 電気部品のピンの幅を検査します。
Pin width control of electrical components
The width of the pins of an electrical component should be controlled.
|
|
N° 105
|
スプレージェットの量の検査 スプレージェットの密度を検査します。
Spray jet amount control
The density of the spray jet should be controlled.
|
|
N° 102
|
フィラメントのスパイラル位置の検査 豆電球に使用されるフィラメント上のスパイラルコイルの位置を検査します。フィラメントのスパイラルには2通りあり、それぞれ間隔が異なります。フィラメントの移動速度はおよそ0.02m/秒で、フィラメントの直径はタイプによって異なりますが最小で0.3mm、最大で1.5mmになります。スパイラルの間隔は最大で1mmとなります。
Spiral position control on a filament
The position of the spiral coil on a filament for the light bulb industry must be controlled. There are two different types of spirals, different in gapping, on the filament. The speed of the filament is approximately 0.02m/s, the diameter of the filament is dependent of the type (min. 0.3mm and max. 1.5mm) and the maximum gapping of the spiral is 1mm.
|
|