Practical examples from the industrial use
L-LAS-RL-10-W
1) Select language:
|
Doppeltplade kontrol på finer Under transport af finer, kan det forekomme at flere lag tages fra stablen. Dette skal overvåges. Double sheet control of veneers During the transportation of veneers, it should be controlled whether one or more than one veneer was picked up from a handling system. |
|
|
|
Diameterkontrol af huller Diameteren på huller i en aluminiumblok skal kontrolleres. Hullerne har en diameter på op til 8mm skal måles. Diameter control of holes The diameter of holes in an aluminum bloc should be controlled. Holes with diameters up to 8mm must be measured. |
|
|
|
Aftastning af et graveret mærke på en metalplade Et graveret mærke, som anvendes til positionering i x-, y- og oprulningsretningen skal aftastes. Detection of an engraving mark on a metal plate An engraving mark which is used for positioning in x-, y- and roll-direction has to be detected. |
|
TOP