N° 558
|
Glue line gap detection on transparent label
On a transparent label a gap in a glue line should be detected.
|
|
N° 363
|
Length control of a metal rod
The length of a steel rod should be controlled. At this, the metal rod will be moved with around 2m/s during the measurement.
|
|
N° 332
|
Detection of super elevations of aluminum profile
Super elevations of aluminum profile should be detected.
|
|
N° 284
|
Position control of filament holders in bulbs
The position of the filament holders in clear as well as red glass bulbs should be controlled.
|
|
N° 268
|
High speed angle measurement with direction control
The angle position of a very fast rotating shaft should be measured; furthermore the direction of the rotation should be controlled
|
|
N° 261
|
Overfilling control of SMD LEDs
The level of transparent casting compound in SMD LEDs should be controlled with regard to overfilling.
|
|
N° 187
|
Detection of the position of optical transparent plastic label on optical transparent plastic film
The position of a transparent label on a transparent film should be detected. At this the speed of the film is in the range of a few m/s.
|
|
N° 121
|
Control of the presence of straight knurling on a transparent plastic closure
On a transparent plastic closure the straight knurling should be detected. On incorrect closures the straight knurling is partly not present.
|
|
N° 111
|
Drop control with a laser through beam system
The number as well as the volume of drops should be controlled.
|
|
N° 109
|
Detection of a welding line on a metal ring
The task is to detect the welding line on a metal ring. During the measurement, the metal ring will be turned around.
|
|
N° 108
|
Knot and defect control of mono filaments
Knots as well as defects on mono filaments and threads should be detected. At this, different diameters of filaments and threads are possible and the feed rate lies in the range of a few m/s.
|
|
N° 106
|
Pin height control of electrical components
The height of the pins of an electrical component should be controlled during the production.
|
|
N° 104
|
Inline diameter control of wooden staff
During the production of wooden staff the diameter must be controlled while the rod is moved.
|
|
N° 49
|
Control of the eccentricity of the shaft of an electrical tooth brush
The frequency as well as the amplitude of the eccentric of an electric tooth brush should be controlled.
|
|